Pulsation Dampers - A.O.D.D. Pumps - Standard Installations

How to ensure lowest in place cost and most performance by standard installation methods.

Pump 3 times farther with no greater air A.O.D.D. supply, make flow as smooth as a turbine, install:- Plastic or SS + Elastomer or "Flexflon", dampers.

INSTRUCTIONS:

2. Please move your mouse over the pump that has your choice of damper type attached to it.
3. When you click on that picture, of materials or damper type, a table of those damper types will appear.

A.O.D.D. PUMPS with Dampers
in PLASTIC "Flexflon" STAINLESS FLO-THRU

Plastic + Elastomer gas bag please go to range price list of off the shelf inventory items, dims. weights and drawing.

Below 40psi the pressure used to drive a liquid of more than 50 cP into a halt, back out again for a "T" piece, leave pulsation in the system.
If you want smooth flow below 40psi, or to be able to flush your system, then always use a FLOW-THROUGH two connection pulsation damper.

Stainless + Elastomer gas bag. Please go to the range price list of off the shelf inventory items, dims, weights and drawing.

Stainless + "Flexflon" please go the SS/LP range price of off the shelf inventory items, dims. Weights and drawing.

Single connection pulse dampers are also available, but flow-thru is standard single connection is more costly. You can always take a 2 connection, using one & then use the other for system drain.

Plastic + "Flexflon" please go to the range price list of off the shelf inventory items, dims. Weights drawing.

Plastic or Stainless wetted + Elastomer flex-tube - For high viscosity, and food or beverage applications. Please go to the range price list, "parts to build" items, and drawing, or select by connection, opposite. LINK

Click Here for Standard Part Numbers for Pump listed by Dimensions & Connection Size

PUMPS make FLOW, SYSTEMS cause PRESSURE, pressure pulsation is a system response,
AND a system responsibility NOT a pump manufacturers liability.